SOLUTIONS

Powering through Rough Terrain

Durapac’s Safe D Lock jack with the unique Battery driven drive system (POWERDRIVE) is easily and effortlessly manoeuvred through rough terrain with just one operator. The Durapac Safe D Lock has the unique POWERDRIVE system which independently controls each wheel. Forward / Reverse, left wheel and right wheel control. The POWERDRIVE makes it effortless and makes it […]

Read More

Custom Built Air Hydraulic Power Unit

A mining company needed a solution to manoeuvre a large piece of mining equipment. They previously used an old Miners pump to operate the two cylinders, however they could only be operated one at a time, which made the process extremely slow and cumbersome. The team at Specialised Force, with the assistance of the Durapac engineers, […]

Read More

Complete Package

Durapac’s SyncMaster Synchronous Lift System with its computer controlled monitoring system and four RSLC-4006T  (400 ton capacity load return locking cylinders) were specially packaged up for a customer performing maintenance on stacker-reclaimers. The RSLC-4006T cylinders feature threaded locking collars which enable loads to be held mechanically and therefore offering additional safety whilst the stacker – […]

Read More

A Levelling Act

An assembly and disassembly bench is used for the maintenance of hydraulic cylinders at a customer’s site. They required an assisted travel rest for levelling the hydraulic rods and barrels. The solution provided included two Durapac RG-55 cylinders used in tandem, mounted side by side on either side of the rollers under the table. These cylinders […]

Read More

Battery Driven Power

A Customer at an Open Pit Mine site in South America used the DURAPAC Safe D Lock SDL-20096-PD; 200 Ton Safe D Lock with Battery Driven POWERDRIVE, SDL150mm and 300mm extensions and Tilt Load Cap to lift their CAT797 Truck.

Read More

Out with the Old ~ In with the New

A RD-5013 Double-Acting Cylinder was used in the removal and replacement of old pipes on an offshore gas rig. The replacement presented the challenge of how to best remove the pipework, bring it up to the deck of the rig safely & then lower the new pipework into place. The challenge faced in this case […]

Read More

Im-press-ive System

A heavy vehicle alignment group customer that provides professional and engineering solutions to the road transport industry needed to offer axle correction systems. They required high force and power hydraulic equipment to suit the roll frame press. The 100 ton roll frame press (pictured) incorporates a DURAPAC 100 ton double acting 150mm & 300mm stroke […]

Read More

Lifting with Power and Safe-D

Durapac’s Safe D Lock™ Jack isn’t just for heavy trucks, it can also lift trains and locomotives. In this application, a customer needed to lift the locomotive to service the tri-mounts on the bogie suspensions. The total load of the locomotive was in excess of 100 tonne and their existing standard 50 tonne hydraulic jacks […]

Read More

More than a Jack

Unlike other jacks on the market, the Durapac Safe D Lock is also a fully Rated Safety Stand. The internal mechanical locking system on the Safe D Lock allows an operator to mechanically lock out the jack with a press of a button. This does away with unsafe locking collars. The Safe D Lock is […]

Read More

Rise to the Challenge

A busy, major city transport bus workshop had a challenge with lifting up buses in their pits, due to the low clearance height of the buses. To get stands or jacks underneath the correct supporting beams they needed a way of lifting the buses up, just enough. The standard bottle jacks they assessed were all […]

Read More